![]() Please help, our Christmas party hinges on this thing working. I’m just dumb with software, very smart with hardware. Please contact your local dealer or our service center. I’ve also heard that high altitude mode works for this issue (I’m 50 feet above sea level, but that’s not the point), but I can’t figure out how to factory reset, and go into high altitude mode because I can’t even remotely get far enough into a menu to even read the words before the fucker (sorry not sorry) shits down again. When the TEMP indicator flashes red, it indicates the fan has failed. I’ve heard that you can factory reset them with a combination of remote buttons, but I tried about 10 different suggestions online, and none worked. ![]() The LED's on the back start blinking red and according to the manual this means 'Over Temperature', but it is definitely a 'Fan Lock' shutdown based on the serial code. First post here, and unfortunately I need some help diagnosing an issue with an Optoma HD65 that I recently purchased used on eBay. I have a Raspberry Pi attached which reads and sends RS232 commands and the projector reports 'INFO6' before it shuts down, according to the manual that means 'Fan Lock'. I can’t reset it because it gives me about ten seconds after the Optoma emblem pops up before I get a “fan locked, powering down” message. Optoma HD65 Flickering + Random Shutdowns. They sound completely fine when it powers up. If your Optoma projector needs service, visit our recommended service centers below and they will help you get a quote on quickly repairing your Optoma EH501 projector. This is pissing me off because I’m abnormally electronics savvy and have torn the projector apart a couple of times and cleaned the fans meticulously, and tested them, and there friggin fine. Our Recommended Optoma Projector Repair Centers. This is pissing me off because I’m abnormally electronics savvy and have torn the projector apart a couple of times and cleaned the fans meticulously, and tested them, and there friggin fine. Then I turned off dinamic black and the projector was silent again. I restarted it, the problem went away, but I realized that the fan noise was too loud. like if the image has broke in two, like a flickering. Sure enough, it switched off automatically after a few seconds, and the LEDs on it flashed. Optoma UHD51A Projector Hisense 55U8H TCL 65R655 > Elite Screens R135WH1 ezFrame. All of a sudden, in the middle of watching something, a message popped up on the screen saying 'Fan Locked' and 'projector will switch off in 5 seconds - contact service centre'. I sent it back to the factory once about 3 years ago for some odd issue, ended up being a color wheel and a power supply. The most worrying issue I've had so far happened about a couple of weeks ago. I have an Optoma HD28DSE that I’ve used for years.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |